Rust causes delays, drives up repair costs and creates damages that can be avoided. DAYWALK’s SKN Peelable Coatings act as a coating to prevent rust and a protective layer for critical assets used on mine sites, coastal yards and laydown areas. They peel away cleanly when work moves to inspection or service, which keeps planned maintenance on schedule.
Unlike traditional rust prevention paint, SKN Peelable Coatings form an even barrier that withstands harsh conditions, then lifts away in one piece when required. Operators can maintain equipment without the mess or extra preparation.
Just as Daywalk’s heavy duty steel pallets and steel stillages are built to last, our peelable coatings are developed with the same focus on durability and reliability.
Showing all 3 results
Maintenance costs are high when corrosion takes hold. The smarter approach is prevention. Daywalk’s industrial rust preventative coatings shield carbon steel, stainless steel and alloys from moisture and oxygen. Used as a metal coating to prevent rust, they extend asset life and reduce recoating.
Coatings alone are rarely the solution. Daywalk designs preservation as part of a bigger picture. Our products range from heavy equipment transport frames to engineered storage solutions that complement protective coatings. Each part of the system is shaped by the same principle: smoother logistics and reduced disruption. This integration gives you the confidence that your investment is fully protected.
Start by preparing the surface properly. Remove dirt, grease or existing corrosion, then dry thoroughly. Once clean, apply the coating to prevent rust on steel in an even layer with a brush or spray. Allow time to cure fully before handling or storage. Following these steps ensures the barrier bonds well and performs for as long as intended.
A rust preventive coating is a physical shield. It stops oxygen and moisture from contacting the metal, the two triggers of corrosion. Daywalk’s peelable coatings add a practical advantage because it peels away in one piece for inspection. For additional defence in storage, silica gel breathers can be used to control humidity inside sealed areas.
Undercoating protects the underside of vehicles from salt and impact. Rust protection is broader. It applies to exposed machinery, stored parts and equipment in transit. Peelable coatings sit firmly in the rust protection category, giving coverage to surfaces that may need both strong defence and easy removal for later checks.
The need to recoat depends on conditions. Coastal or humid sites often need fresh film every few months. Indoor storage usually lasts longer. Inspect on a schedule and reapply before wear shows.
Longevity depends on exposure. In sheltered storage, protection can hold for many months. Outdoors, UV, rain and airborne salt shorten that window. Plan inspections and reapply as required.
No. Once peeled away, the film cannot be reapplied. A new layer should always be used to ensure full coverage and effective protection.
Wrapping and films can protect equipment during storage or transit, but they often trap moisture if not applied correctly. A peelable coating to prevent rust creates a sealed barrier directly on the surface, blocking oxygen and water from the start. It can also be removed in one layer, which makes inspection faster and reduces the risk of hidden corrosion.
